Rotating Drum System
Used to inspect friction between a rotating surface and sheets, the H16 can be used for textile, film and paper measurement, as well as assessing friction and wear characteristics of coated or plated surfaces (on the drum).
The sheet of test material is placed over 1/8 to 1/2 of the drum’s diameter. A load is applied to the sheet and the other end connected to a strain gauge. When the drum rotates, friction occurs and its resistance is detected and displayed.
$48,500.00
Additional
| Weight | 81 lbs |
|---|---|
| Dimensions | 31 × 20 × 30 in |
Related Products
-
H38
$28,900.00Benchtop low cost surface property tester including a 1000gf loadcell, Sapphire needle(0.05R 90 degrees x 1), Vertical gauge for sapphire needle(1), a set of combination deadweight, Power cable(1), Acrylic resin cover(1), Parts box(1), Tool spanner(1) and Operating instruction manual(1). Commissioning and Tribosoftware w/PC are not included. The set of combination deadweight includes 200gx1, 100gx2, 50gx1, 20gx1, 10gx2, 5gx1, 2gx1 and 1gx1.
-
Heidon Optical Strain Gauge
$7,895.00This unique device helps identify stress points on transparent and translucent plastics and polymers. Utilizing the principle of polarization, two film plates are turned to provide the optimal viewing index. Stress points are easily viewed through the large (280mm) circular viewing window.
-
Reciprocating wear tester
$12,900.00This simple reciprocating tester allows adjustment of travel speed and distance Simultaneous testing is also an option as multiple samples can be run. The H30/30S has a maximum travel speed of 33000mm/min and a maximum travel distance of 50mm.
-
Scratch Tester
$22,700.00Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured.
Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness an be measured by using a fixed load instead of the continuous load module. This system includes an analog output and PC data collection system.