Continuous Load Tester
Similar to the H18L, the H22 allows a ball indenter to be loaded in addition to scratch needle loading. Thin to thick film adhesion, real-time measurement of friction (due to abrasion), surface scratch hardness and tackiness can be evaluated by this system.
$72,500.00
Additional
| Weight | 81 lbs |
|---|---|
| Dimensions | 31 × 20 × 30 in |
Related Products
-
Vacuum Friction and Wear Tester
$124,000.00The Tribovac2000 is a vacuum friction and wear tester designed to incorporate various types of testing equipment inside a vacuum tank. It contains support for various types of friction and wear testing along with various testing conditions. As a loading method, this instrument utilizes the weight loading switching method with a turntable of 60mm as its diameter.
-
Low-Load Wear Tester
$44,500.00This tribogear tester has a loading range from 0.1g to 10g and contains a housing that separates the drive unit from the measuring unit in consideration to the very low loading conditions. This provides unsurpassed precision by isolating even minor vibration. The upper sample fixing method utilizes the sample fixing jig with a table rotation speed that ranges from 30-3000 rpm.
-
Portable Tactile Meter
$29,700.00The H33 is a a portable tactile meter that expresses sensory evaluation in numerical values. This meter can measure slippiness, blending, texture, and feeling. Its measurements range from 0-20N in X,Y,Z directions.
-
Scratch Tester
$17,500.00Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured.
Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness can be measured by using a fixed load instead of the continuous load module. This system does not have an output module