Subscribe

Kett Product Categories » Products » Friction, Wear and Surface Property Analyzers
 
Product ID H10
Static Friction Tester

Install a test piece onto the ascending board under the flat indentor. The ascending board is equipped with a sensor that monitors the motion of the flat indentor.

The ascending board is normally in the horizontal position. The board inclines and the sensor detects motion when the flat indentor starts sliding. The system is then stopped and the angle is measured to calculate the coefficient of static friction.

Price: $12,500.00
Product ID H14S
Desktop Tester
The 14S provides immediate, accurate readings of many types of property measurements. By being able to measure static and dynamic friction coefficients, adhesion, scratch hardness, stickiness, tensile strength, and peel resistance with one unit, lab space is minimized and a consistent interface for measurements and data collection are provided. Various tests can be performed by changing test fixtures (jigs). This system does not include the ability to output data.
Price: $42,500.00
Product ID H16
Rotating Drum System

Used to inspect friction between a rotating surface and sheets, the H16 can be used for textile, film and paper measurement, as well as assessing friction and wear characteristics of coated or plated surfaces (on the drum).

The sheet of test material is placed over 1/8 to 1/2 of the drum's diameter. A load is applied to the sheet and the other end connected to a strain gauge. When the drum rotates, friction occurs and its resistance is detected and displayed.

Price: $48,500.00
Product ID H17
Adhesion and Peeling Resistance Tester
Used in peeling and tensile strength assessment. The H17 contains a test piece that clamps on both sides, moves at the same speed, and evaluates the resistance on the object. This adhesion and peeling resistance tester is simple to use and contains the ability to measure a wide range of contents.
Price: $28,500.00
Product ID H18
Scratch Tester

Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured.

Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness can be measured by using a fixed load instead of the continuous load module. This system does not have an output module

Price: $17,500.00
Product ID H18L
Scratch Tester

Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured.

Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness an be measured by using a fixed load instead of the continuous load module. This system includes an analog output and PC data collection system.

Price: $22,700.00
Product ID H18LFW
Reciprocating Scratch Analyzer

Advanced reciprocating scratch and surface property analyzer. Touch screen control and digital data collection software.

Price: $49,000.00
Product ID H20
Disk / Ball Friction System

Disk-on-disk and ball-on-disk friction coefficients and abrasion can be measured with the H20. A disk or ball indenter is loaded onto the test piece and connected to a highly-sensitive straingauge. As the turntable rotates, the load is transmitted to the PC software to display measurements up to 999,999 revolutions.

Rotational speed can be set between 10 and 600 rpm for varied analyses. Even delicate changes in friction can be readily identified and quantified for coating assessment or lubricant evaluation.

Price: $29,500.00
« Previous | 1 | 2 | 3 | »